That was too easy! I did as Bill suggested and used a Y connector. --... ...-- Forest WA2MZG
-----Original Message----- From: Don Wilhelm [mailto:[email protected]] Sent: Thursday, October 29, 2015 5:56 PM To: Forest Shick <[email protected]>; 'Martin Waller' <[email protected]>; [email protected] Subject: Re: [Elecraft] KX3 to Computer Forest, That sounds like a problem between you and your computer. If you are specific about the computer you are using, perhaps someone with the same setup can help you. I think the solution (if any) will be found in the soundcard mixer. It may or may not allow the selection of Line Out plus speaker. 73, Don W3FPR On 10/29/2015 5:40 PM, Forest Shick wrote: > Thank you for all the information. > I set the MIC BTN to OFF and adjusted the MIC GAIN for 4 bars (ALC) and turned on VOX. > > I am able to TX and RX SSTV, PSK32 and RTTY. (No contacts mostly > receiving and transmitting into a dummy load until I have all the bugs > worked out.) > > BUT I have to disconnect the LINE OUT from the computer to monitor the received signal and then plug it back in to transmit. > > Plugging in the LINE OUT connector to the computer mutes the computer speaker. > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
