Let’s make sure the K3 and KPA are communicating. When you power on the KPA, does the K3 indicate that something changed? It should display the KPA power event on the display. If not: * what cable are you using between the K3 and the KPA? * Check the RADIO setting in the KPA. It should be set to K3.
Is there anything else connected to the AUX IO ports on either the K3 or KPA? - Jack Brindle, W6FB Elecraft Engineering > > On Oct 30, 2015, at 10:23 PM, NE9U - Jasper <[email protected]> wrote: > > Just hooked a new kpa500 to a k3. > > when switching bands on the k3, the kpa500 doesnt follow. it does follow > when i apply power. > > the reverse does work....if i switch bands on the kpa500, the k3 follows. > > tried 2 different auxillary cables...same result with both. > > am i missing some setting i need to change? > > scott ne9u > > > Sent from Republic Wireless Cray-1 > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
