Dave,
If you use a non-standard method of connection, that provides difficulty
if you ever have it serviced. I routinely swap out full options when
doing troubleshooting (substitution is the quickest way to isolate a
problem). If you use a non-standard connector, that cannot be done.
That 2mm will not cause a problem at all. L20 will likely move toward
the rear a bit if you bend over C202 and give it a slight push.
73,
Don W3FPR
On 11/13/2015 5:43 PM, David Brown wrote:
This post is for K2 builders that have the internal KAT2 ATU. I am
completing a K2 build that will include the KAT2. The 2-pin connector (P6)
on the K2 RF Board connects to the RF input on the KAT2. There is a
clearance problem where inductor L20 overlaps the footprint of P6 on the RF
board. This overlap is about 2 mm in my case. The recommended solution to
this overlap is to simply unsolder L20 and roll it forward to eliminate
this overlap. I am uncomfortable with this and am thinking about using an
alternative method to make this connection. I'm interested in hearing from
other K2 builders who may have used an alternative to P6 because of this
interference issue.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
