I experienced the same phenomenon as did Larry. Some of this was the "fault"
(i.e. normal operation) of the noise blanker; some of it was due to the
absolutely abysmal quality of too many of the signals. Regrettably, there were
probably some K3s contributing to the mess if some recent QSOs I've had with
other owners are any indication. Although I often get unsolicited kudos for my
audio, I recently had a 17-meter ragchew with a W6 transplant in GA whose K3
sounded simply awful and looked it on the spectrum scope.
Regarding the K3 NB, frankly, I wonder why, with a radio with so many "smarts"
built in, we have to adjust I-F NB parameters at all. Setting the threshold
automatically, under most conditions, should be automatic and extending the
blanking pulse width to match the noise impulse duration should be trivial.
See: http://k6mhe.com/n7ws/Noise_Blanker.pdf for some ancient work.
(I actually wrote this paper as a final exam for a technical writing course I
took. We were told to write something suitable for publication, including
letters of submission and a release from the company I worked for. I said to
myself, "Self, you've done all of the work, why not just for the heck of it
submit it to a ham radio publication? Since the company only gave "published
papers awards" for peer-reviewed publications, I figured I really didn't require
their approval so I sent it to Ham Radio Magazine and they paid me instead. A
couple of years later a guy said to me, "I see your circuit was published in
Bill Orr's Radio Handbook." First I knew about it. One would think that a guy
who stole your work would at least give you a free book; but no.)
On 11/20/2015 8:00 PM, Eric Swartz - WA6HHQ, Elecraft wrote:
Hi Larry,
For the IF NB I usually use a level of 3, or 4 max, with a narrow typically
for the width. This generally works quite well for me with minimal intermod.
More aggressive thresholds and wider widths significantly increase the
likelihood of nearby strong signal intermod with IF based NBs.
As another poster mentioned, the DSP NB can be cascaded after the IF NB, or
just on its own. So trying different combinations of these may also help in
your situation.
Eric
/elecraft.com/
On 11/20/2015 3:00 PM, Larry - K1UO wrote:
I discovered the source of a “noise” I was complaining about on 80M cw this
AM. I finally noticed that it would always come on at exactly the time VK9WA
said “UP”!! and varied in intensity and duration until he answered
someone..at which time the noise was gone and S meter returned to S1!! Seems
like the NB settings on the K3 are causing IMD and phase noise from the
pileup up the Band a bit to sound like rain static and jump to a level of
S5-6 on the K3 meter! Never ran into that before with a K3... Then again,
except for this new electric fence pulse, I never needed to use the NB for
anything at this previously dead quiet location. Any ideas on what
settings I should use or try for this electric fence noise? Possibly the
settings that I am using are too aggressive and would cause this?
Regards
Larry K1UO
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
