Hi Steve, Sorry to hear about this. I've never heard this complaint before (and there are tens of thousands of these speakers in use, in both the K3 and K3S). The frame should not bend if the correct fibre washers are used and the hardware is not over-tightened. I'll check with our manufacturing lead to see if the wrong ones were shipped.
I'll also check with our tech writer. Perhaps the instructions could be clarified. The internal speaker is certainly of high quality, so I hope you can get one installed (I'm sure customer support will send another, given your issues). It has excellent sensitivity (95 dB SPL, due in part to the very large shielded magnet) and a wide frequency response range. Given the large top cover mounting surface, the internal speaker is quite loud, with a low natural resonance point. 73, Wayne N6KR On Dec 5, 2015, at 11:59 AM, Steve Ellington <[email protected]> wrote: > I've made 2 attempts to install a speaker in my new K3s but they bend like > butter and distort. I was very careful to use the fiber washers and to not > over tighten the bolts. The frame of the speaker can bent with 2 fingers! > I've never seen such a flimsy speaker. > > I had a brand x speaker in the junk box that worked great but I wanted it > to be original especially since the speaker is necessary to hold down the > sub receiver's shield. The junk speaker worked fine while I awaited a > replacement but the new replacement did the same. Basically it is junk. > I wonder if they washers they sent are too thin? > > I never use the internal speaker anyway but feel like it should at least > work. > > Has anyone else noticed this? Otherwise I love the K3s! > > Steve N4LQ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
