Try loosening *ALL* of the case screws - bottom covers, front panel, side panels, rear panel and top, including those around the fan panel (or the blank panel if you have a K3S/10 - no 100 watt amp), KIO3 and KXV3 panels on the rear. But DO NOT loosen the screw in the side panel with the feet at the top rear corner near the ANT 1 connector. Don't take them out, just loosen them.
Then set the K3s on a flat surface and retighten them, standing the rig on its side feet do to the bottom screws last. 73 Ron AC7AC -----Original Message----- From: Elecraft [mailto:[email protected]] On Behalf Of Bob Novas Sent: Sunday, December 6, 2015 7:33 PM To: [email protected] Subject: [Elecraft] K3S rocking on flat surface I must have done some kit assembly wrong. My K3S does not sit flat on a flat surface, rather it rocks. Furthermore, the seam on the bottom between the front and back cover plates is not flat. Any hints as to what to look for? Bob - W3DK ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
