I would need to agree with this post. I had a 2D fastener install
incorrectly in my K3. I had the same issue.
Rich
K3RWN
On 12/6/2015 10:59 PM, RIchard Williams via Elecraft wrote:
Bob,
I would take a look at the six 2D fasteners you installed in the corners of the
RF board. If one is installed the wrong way, I am betting that would cause the
problem you are experiencing. There are four additional 2D fasteners used (2
on the front panel shield, 1 in the top back corner of the left side panel, and
one in the upper read corner of the right side panel), and you might double
check they are orientated correctly to.
Dick, K8ZTT
From: Bob Novas <[email protected]>
To: [email protected]
Sent: Sunday, December 6, 2015 8:33 PM
Subject: [Elecraft] K3S rocking on flat surface
I must have done some kit assembly wrong. My K3S does not sit flat on a flat
surface, rather it rocks. Furthermore, the seam on the bottom between the
front and back cover plates is not flat. Any hints as to what to look for?
Bob - W3DK
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
