Bruce, when you tune the guy in FL1, are you tuning him in at the same pitch as the spot tone?
de w1rt/john On 2/12/06, rattray <[EMAIL PROTECTED]> wrote: > I've been enjoying operating my K2 for quite a while now - but one thing has > bothered me and that is my alignment of the CW and SSB filters - my main > problem is that I only have a basic understanding of what I'm doing - I feel > I need a better understanding which will result in a better alignment of the > filters for both modes - > - here's what's bothering me - I can tune in a cw signal on the widest > filter position XFIL#1 and when I switch to positions 2, 3, & 4 [I've set > them for 1.50, 700, 400, 100 cycles], I either lose the signal and have to > retune for it or the signal is there but certainly a different tone and down > in volume - it seems to me that if I have them set right, I shouldn't have > to retune and the volume should be ok - > - so I got out my N0SS noise generator and put a new battery in - booted up > the 10 minute Spectrogram program, set it's parameters according to > instructions I printed off the Elecraft Builders' Resources, set markers at > 600 & 2000 hz and turned on the noise generator - then I went through all > the steps, 1 through 15, for the CW alignment and adjusted the waveforms for > each position - then returned the K2 to normal operation - > - I tuned in a 40 mtr cw signal in the widest position, then switched in > the next xfil position - the signal disappeared and I had to retune it in - > then when I switched XFIL through the other positions I didn't have to > retune - maybe I've made some progress seeing I don't have to retune xfil > positions 2,3, & 4 - > - so I'm looking for suggestions on how to approach this procedure so I can > tune in a cw signal in position 1 and then switch in xfil positions 2,3, & 4 > and not lose the signal - then of course I'll be looking at SSB - tnx & 73 > Bruce. > > 72/73 - Bruce ve5rc/ve5qrp - QRP-C#1, QRP-L#886, A1 Operator > Enter QRP-Canada's "RUN with RAC" contest - > details - http://www.qrp-canada.com > > > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
