Keith,
Check your audio, you should be driving the audio so you have 4 bars
illuminated with the 5th bar flickering on the K3S ALC meter.
If you are operating in USB mode, I suggest you change to DATA A data
submode. That will automatically set compression off and the
equalization to flat.
You have 2 controls to adjust the audio drive. One is in the computer,
set the slider for the soundcard in use to about 2/3 of full scale for
starters, and set the MIC SEL to LINE IN - the MIC Gain control in the
K3S will allow you to control the gain of the LINE IN signal.
BTW, if you are using the internal soundcard in the K3S, make certain
you do *not* have anything plugged into the K3S LINE IN jack. If you
do, the LINE IN audio from the internal K3S soundcard will be ignored
and whatever you have plugged into the LINE IN jack will take precedence.
You can adjust the audio levels by placing the K3S into TX TEST mode and
no RF will be produced. Once the audio levels are correct, you can
adjust the desired power level with the POWER knob.
Once the audio levels are set, adjust the VOX gain for reliable transmit.
73 and HNY,
Don W3FPR
On 12/29/2015 8:12 AM, [email protected] wrote:
Merry new year to all.
I am having trouble operating HRD psk31 to my K3s.
I can set it up to receive via the K3s usb no problem. The tx is produced
by the pc but not keying the K3s.
I have tried all the settings in the manual.
I also us the P3 all linked to the pc with the proper cables.
Any ideas?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
