John,
Another thing - you could have a bad coax between the KX3 and the dummy
load - overlook nothing, especially simple things like that which are
often forgotten. Make no assumptions about the 'goodness' of cables and
any adapters. Substitute a known good cable, or disconnect it from the
KX3 and measure that end with an antenna analyzer.
73,
Don W3FPR
On 1/10/2016 11:08 AM, VE3NFK wrote:
Hello
Just finished updating firmware; using latest utility pgm; radio works fine
- 'tune' into dummy load gives 1.1-1.
Calibration from utility instantly fails at 1.900 99.9-1 SWR.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
