Well, first, I don’ recognize the CBLP3T cable. Maybe you meant CBLP3Y? If so, I think yu would still need a DE-9 “Y” cable to connect at the P3 at which ever port you used before (TXCVR or PC).
Be sure to set CONFIG:RS-232 to USB and not 38400 as before. And now your audio input/output is the new USB CODEC. Have fun and let us know how it works. …bc nr4c > On Jan 18, 2016, at 4:24 PM, N2TK, Tony <[email protected]> wrote: > > I installed the KIO3B kit. I have it set up as the original KIO3 - K3- RS232 > to P3 to PC/SteppIR. Accessory plug with FSK interface and audio in and out > cables to audio board. I use LP-Bridge. Everything is working fine as it was > before the upgrade. > > Now I want to take advantage of the features of the KIO3B kit. > > > > I have the CBLP3T cable for the K3 to the P3. > > I will replace the RS232 with the USB to the PC. > > I will remove the audio in and out cables. > > > > Is there anything special I need to do now that I will be using a USB port > instead of the RS232? > > What about with LP-Bridge? Anything I need to do with it? > > Where is the best place to hook up the SteppiR now that I don't have an > RS232 connecting to the PC? > > > > Tnx for any feedback. > > 73, > > N2TK, Tony > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
