I tried installing the USB cable from the K3 to the PC. The only thing that happens is that in Device Manager >Universal Serial Bus Controllers it show two USB ports added - Generic USB Hub and USB Composite Device. What do I do next? How do I get this tied into LP-Bridge as before as there is nothing showing on LP-Bridge how to handle USB connections?
Tnx for any input. N2TK, Tony -----Original Message----- From: Elecraft [mailto:[email protected]] On Behalf Of N2TK, Tony Sent: Monday, January 18, 2016 4:25 PM To: [email protected] Subject: [Elecraft] K3 - KIO3B setup I installed the KIO3B kit. I have it set up as the original KIO3 - K3- RS232 to P3 to PC/SteppIR. Accessory plug with FSK interface and audio in and out cables to audio board. I use LP-Bridge. Everything is working fine as it was before the upgrade. Now I want to take advantage of the features of the KIO3B kit. I have the CBLP3Y cable for the K3 to the P3. I will replace the RS232 with the USB to the PC. I will remove the audio in and out cables. Is there anything special I need to do now that I will be using a USB port instead of the RS232? What about with LP-Bridge? Anything I need to do with it? Where is the best place to hook up the SteppiR now that I don't have an RS232 connecting to the PC? Tnx for any feedback. 73, N2TK, Tony ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
