K3s is coming next week. I have my existing K3 set up the way I like to use it and have saved the configuration via the excellent utility.
The K3s is coming completed, I will immediately put the 100W module and the ATU in place. I currently have a sub Rx in the K3, I will move it to the K3s once I have completed upgrading the low frequency modules and perform the needed updates on the Sub Rx. I haven't done any soldering to surface mount components and need to first practice on a junk component so I may not get those soldering changes done right away. Soon, but not till I feel 100% secure I will do a perfect job. I'd like to start using the new rig ASAP but would like the setup to be like my K3 is, using as examples; my saved selections for RTTY & DSP. - Will I encounter any unexpected problems if I load my K3 configuration to the K3s and start operating? - If the answer is no, will there be any negative issues to the normal operation of the K3s if I change the configuration of the K3s to that from my K3 which has the sub Rx, if I do so before adding the sub Rx to the K3s? Or will I need to put the Sub Rx in before importing my K3 configuration? If there will be issues then I should run through all the various configuration settings and write each of them down. There's a lot to do if that's the case and it will be awhile before I get all those settings in a list. 73 & thanks, Gary KA1J ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
