I forgot to mention that I also will set the tuning bars in cocoaModem as close to 1275/1445 (my preferred tones) as I can and often use the XY tuning indicator in CCM.
BTW, CCM also has the benefit of being able to use both VFO's and tuning for the next call while I wait for the "NR?'s and AGN?'s" to be finished on the main receiver. That way is I have a secondary station tuned in on the SUB I can do a quick A/B switch to work the next one. Rick K6LE On Mon, Feb 15, 2016 at 5:57 AM, David Kuechenmeister <[email protected]> wrote: > I ran my K3 with the K3IOB upgrade card installed. I also have a P3 and > set it to a 10 KHz span. Before, when I used the line out as an input to > Fldigi, it seemed like there was a little more tolerance in how I tuned in > on the space signal. Now, I notice that the K3 decodes text when I get > reasonably close to the space signal, but Fldigi still needs a little more > finagling to get it decoding at all. > I may be back to using the Xonar sound card and cables unless I can > establish a more consistent tuning procedure on the RTTY signals. > vy 73,Dave N4KD > > > > On Monday, February 15, 2016 12:22 AM, Rick Prather <[email protected]> > wrote: > > > I used RUMlogNG for WPX and it worked very well. > > My set up though is a bit different than your's I think. > > I use the K3 set to FSK D and cocoaModem as a back up. I tune the signals > using my P3 set to about 15 Khz span and tune to the Right (space) signal. > The only repeats I needed to give didn't surprise me since I am running > only 100W to a wire. > > I found that cocoaModem was slightly better at decoding but most of my > decodeing and therefore grabbing call signs, etc. was from the RUMlogNG > display with cocoaModem used mostly as an occasional backup. > > Interestingly enough, I found a few situations, especially on weak and/or > fluttery signals, where the K3 did a much better job of decoding than > cocoaModem. > > I also spent some time running FLDIGI on the side but found it was not > nearly as good as cocoaModem or the K3 in decoding. > > Rick > K6LE > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
