Deane, I have discovered the same. It kind of acts like an SWR meter put *after* a tuner.
If I use a resonant antenna or transmit into my dummy load, I don’t get these squirrelly readings. 73, Joel - W4JBB > On Feb 21, 2016, at 6:23 PM, Deane Walkington <[email protected]> > wrote: > > I have recently installed the Txmon and have seen some peculiar Power and > SWR readings on the P3 Display. Power levels much higher than the K3 is set > to and SWR readings much higher (10:1) than the K3 indicates (typically > 1.2:1). I connected the Coupler to the K3 ANT 1 socket via a short coax > patch cable. What is the preferred method of connecting the Coupler - a UHF > male to male adaptor or a short length of coax? At present I have > disconnected the coupler from the radio and the P3. > > > > Dean > > VK1DW > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
