Hello Bill,
During normal operation there a no clicks when changing a filter.
My K3 is an older one, but ever since I have the NEW SYNTH's on board,
there's a lot of clicking going on when I change the width of the
filters in Diversity mode.
Nothing to worry about. I think the relays are on the new Synt-boards?
Everything works. The diversisty is brilliant.
73
Arie PA3A
Op 24-2-2016 om 0:53 schreef Bill OMara via Elecraft:
I'm the proud owner of four K3 radios at my contest station and one of my
new K3 (89XX) is doing something different than the other three and I'm
trying to understand what it's doing.
In the diversity mode as I change the width control and reach the selection
points for different CW filters to be selected I hear what sounds like two
(one after the other) clicks of what I'm guessing is the two new filters
being selected as the width is either decreased of increased. This same dual
clicking sounds happen at each filter selection point.
What's weird is that the other three K3 radio don't do this. Is it a
different configuration setting? If so, what is the configuration setting?
This same radio doesn't make any clicking sound when changing the width
control, filters when it's NOT in diversity mode.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
