Your SSB bandwidth (passband) is prob 2.7 kHz and your CW passband might be 400. You not only have to consider the side and but your side tone offset and bandwidth.
There is a setting in the CONFIG menu to make this work however. Sent from my iPhone ...nr4c. bill > On Mar 14, 2016, at 8:28 PM, Bob Novas <[email protected]> wrote: > > When I'm in SSB mode and I tune down to the CW frequencies, I can easily > tune in a CW signal. Then, I switch to CW mode, and the CW signal is gone > because I'm on the wrong sideband. Even if I'm on the right sideband, the CW > signal disappears. Shouldn't I be able to switch from SSB to CW and not > lose a CW signal? Am I doing something wrong? Thanks, Bob - W3DK > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
