Hi Don, Ok, thanks for the info. Would a resistance check according to the schematic be reliable at this point (just finished the varactor diode installation steps)? I dont know if I want to try to power anything up in the half built state lol.
I'm pretty confident in the daughter board since I checked it over after flush cutting it, etc. One of the pins got hot enough to melt the solder on the daughter board itself while I was soldering it to the RF board (my fault for holding heat onto the pad at RP3 too long) and it rocked out of place a bit before I repositioned it. It looks ok and I dont know if I dare try to get my soldering iron in there to try to "touch it up". So I'd just like to do a continuity check on that pin. And maybe the whole board while I'm at it? Thanks kind sir, LS W5QD -- View this message in context: http://elecraft.365791.n2.nabble.com/K2-thermistor-board-check-tp7615784p7615790.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
