After looking at the help pages, I don't see anything that would allow configuring the radio menus such as filter bandwidth settings etc. I can't run the program with my K2 yet because I have yet to build the 100w amp/serial interface. Are you sure this lets you configure the menus? Thanks Rich KE1EV
http://www.richardcarter.net/ > -----Original Message----- > From: G8IFF/KC8NHF [mailto:[EMAIL PROTECTED] > Sent: Sunday, February 26, 2006 2:22 PM > To: [EMAIL PROTECTED] > Cc: [email protected] > Subject: Re: [Elecraft] Remote control software > > Ham Radio Deluxe, amongst others may help. > http://hrd.ham-radio.ch > > > Richard Carter wrote: > > >At the risk of sounding like I'm criticizing the K2, I'd like to say > >that the menues are awkward to set. Unless I have a cheat-sheet of > >some kind, I can't find my way through them. I suppose this > isn't such > >a big deal because most of the menue settings are a set once > and forget > >or at least a rare change. It would be so much easier if > there were a > >remote control application that allows access to the K2 > menues, but I > >can't find one. Does anyone know of such a program? > > > >http://www.richardcarter.net/ > > > > > > > > > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
