Don't know as I don't have a K2 but it should allow all facilities that
Elecraft included in the CAT commands. Check your manual.
Richard Carter wrote:
After looking at the help pages, I don't see anything that would allow
configuring the radio menus such as filter bandwidth settings etc. I can't
run the program with my K2 yet because I have yet to build the 100w
amp/serial interface. Are you sure this lets you configure the menus?
Thanks
Rich KE1EV
http://www.richardcarter.net/
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
