George, Not sure how to set up VOX using an internal sound card. For use with my SignaLink USB, I simply adjusted the output level of the sound card until it properly keyed the transmitter.
Also Chapter 6 in the Elect KX-3 manual covers VOX setup. See page 66. I am also using USB rather than Data mode for decode with WSJT-X v1.7.0 dev. I have been able to consistently get decodes down as low as -26 to -27dB. 73, Bob Nobis - N7RJN n7...@nobis.net > On Apr 10, 2016, at 16:58, George_yv5wz <yv...@hotmail.com> wrote: > > Hey Robert > > > Yes I think I'm ok with my Sony VPCW12AX.....probably is cause better sound > device than laptop hahahaha...... > > I have WSJT-X v1.6.0 r6263 > > What are the settings for VOX? > > By the way my software decode with KX3 set at USB.... I couldn't get any > decode set at DATA > > > 73's > > > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/What-s-best-Soundcard-Interface-for-KX3-tp7616157p7616188.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to n7...@nobis.net > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
