I have a setup exactly like the Wilcox Engineering setup. I have a
second K2 with the KAT2 installed just for QRP, but I've had it
connected to the KPA100 also. Works fine and is a very impressive little
package on the desk.
The Wilcox Eng. text says to be sure to power up the KPA100 before the
K2. I'd never heard that before. I power both with the same power
supply recommended and sold by Elecraft. I hit the PS switch then the K2
front panel switch, so maybe that's what he means.
Eric
KE6US
On 4/16/2016 9:43 AM, Kevin Stover wrote:
http://wilcoxengineering.com/kpa100-in-ec2/
You've got to have the KIO2, an EC2 enclosure, and the KAT100PNL kit.
KIO2 goes in the QRP K2, KPA100 and KAT100 go in the new EC2 enclosure
which has the KAT100PNL kit installed.
Assuming you've got the KAT100-1 you can use the serial cable you
built. K2 end goes to the new KIO2, tuner end goes to either the
KPA100 or the KAT100, left over connector goes to PC.
On 4/16/2016 10:47 AM, Dauer, Edward wrote:
Another possibility for a quick conversion to QRPis to move both the
KAT100 and the KPA100 to an EC-2 enclosure and install the KAT2 in the
base K2. I have seen references in the archives to the possibility of
doing that conversion, but they leave a number of questions open. Once
the KPA100 is installed in the K2, is it possible to move it over to
an EC-2 with the KAT100? If so, is there a procedure published somewhere?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
