I just added some filters to the K3s and configured the filters with the K3 config. The radio hears perfectly on all the modes and the filters are working beautifully. now however, it does not transmit. It is not in test mode.
I did nothing else to the radio while I had it open. Tapping a key, SSB or pressing XMIT and there is zero output.this at 1W or 25W. The red TX LED lights. It signals the relay in the amp properly. On the P3 transmit monitor I see .02-.03W PEP registering, no SWR reading and the LP-100A shows no sign of a signal. I restored a known good configuration with no change. No error messages are showing, no warning message on startup. 13.6 V on the K3 meter. trying the ATU, it shows 5W on the display, relays clack, no output on the P3 output except that .02-.03W & nothing on the LP100A I have triple checked to be sure all the coax to the Synths, TXCO & Sub are attached properly. I have made sure all the connections to the sub RX are inserted properly. I must be missing something obvious. Any ideas what I might look at? Thanks Gary KA1J ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
