Gary,
If K3 Utility does not do the job for you, use the K3 menu directly -
see page 51 in the manual.
Go into the menu and set all your filters to ON. Set FLx BW, FLx FRQ,
FLxGn, FLX ON for each filter. Then set FLTX to the appropriate filter
per mode. For CW and SSB set it to the 2.7 (or 2.8 filter), For AM, 6
kHz if available, otherwise the 13kHz, for FM the 13kHz if installed.
K3 Utility should show you the same thing as recorded in the menu.
Make sure the filters are plugged in the K3 RF board from highest to
lowest as indicated on the silkscreen.
Has it been working before? or is this a recent problem? If working
before, what has changed?
73,
Don W3FPR
On 4/27/2016 9:18 PM, Gary Smith wrote:
There is:
2.8K is for CW and SSB
6K is for AM and the FM is checked by default.
Installed in the main is:
FL1 6K - {AM}
FL2 2.8K - {CW & SSB}
FL3 1K
FL4 400 Hz
FL5 200 Hz
Sub:
FL1 6K
FL2 2.7K
FL3 1K
FL4 500 Hz
FL5 250 Hz
When running through Config I only see FL4 listed, no other filters
show up as in FL5, FL3, FL2 & FL1
FL4 Config options read:
FL4 BW rF .40
FL4 FREQ rF 0.00
FL4 GN rF 0db
FL4 ON rF yes
FLTX SB FL2
73,
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
