On Mar 1, 2006, at 6:06 AM, Lee Buller wrote:
OK....I know that this might be a dumb questions, but before I do
a dumb thing I want to ask the question. I have two rigs...one of
which is the K2/100. I have a two position coaxial switch (I think
it is a Diawa CX201A) that I picked up at a hamfest. Is there
enough isolation between the two positions where I could switch
between two rigs? I don't want to blow out the front end of either
rig. I would think that if you are using one rig, the other rig
shouldn't be on or if it is on should not be on the same band.
Again, would this be something stupid to do or is it something that
is done routinely?
Lee- K0WA
I am not familiar with the Daiwa switch, but the ones I use (Alpha-
Delta and MFJ) ground the unused sections and the isolation is quite
good.
Bob, N7XY
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
