Lee, It all depends on the switch - some isolate quite well, but others are really bad. If you want ot be really safe, rig up a relay for each transceiver to do the switching task and short the coax going to the unused transceiver.
73, Don W3FPR > -----Original Message----- > > OK....I know that this might be a dumb questions, but before I > do a dumb thing I want to ask the question. I have two > rigs...one of which is the K2/100. I have a two position coaxial > switch (I think it is a Diawa CX201A) that I picked up at a > hamfest. Is there enough isolation between the two positions > where I could switch between two rigs? I don't want to blow out > the front end of either rig. I would think that if you are using > one rig, the other rig shouldn't be on or if it is on should not > be on the same band. Again, would this be something stupid to do > or is it something that is done routinely? > > Lee- K0WA > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
