Is the K3 ATU in bypass?
Eric
/elecraft.com/
On 5/6/2016 11:26 AM, Don Wilhelm wrote:
Ramon,
There is a calibration procedure in the manual to calibrate the wattmeter for
forward power, but not for SWR.
I suggest you contact K3support for further assistance.
73,
Don W3FPR
On 5/6/2016 11:50 AM, Ramon Tristani wrote:
The VSWR indication in my K3 seems to be off considerably when connected to a
50 ohm dummy load. An external VSWR meter indicates 1:1 while the K3 most of
the time indicates readings varying up to 2:1 at times. I am using the same
short coax stub to connect the instruments one at a time to eliminate other
possibilities. Is there a way to “calibrate” the VSWR indicator in the K3? My
K3 is serial number 4416. The Auto Tuner in it works fine and reduces the
indication to 1:1 as it is supposed to but when bypassing it the VSWR
indication will always be off. Any suggestions?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to eric.swa...@elecraft.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
