Are you using virtual com port software that's not up and running before you start fldigi? Are you saying "yes" to the save settings popup when closing after you fix the problem?
-Bob On Mon, May 23, 2016 at 3:13 PM, Paul Christensen <[email protected]> wrote: > Dave, > > Correct. I must always initialize Fldigi with my K3. Once initialized, > it's works fine. If I close it and re-open, initializing is needed again. > > Paul, W9AC > > On Mon, 2016-05-23 at 13:19 -0400, Paul Christensen wrote: > > Jerry, > > > > Thanks for the tip. I'll use a macro in Fldigi if there's no simple > > solution available. > > > > Paul, W9AC > > Paul, > > If I understand you correctly, you set things up in FLDigi, get them > working, and then if you close the program, and restart it, the rig is > no longer controlled. Is that correct? > > > > -- > 73's, and thanks, > Dave (NK7Z) > For software/hardware reviews see: > http://www.nk7z.net > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
