>”Are you using virtual com port software that's not up and running before you >start fldigi? Are you saying "yes" to the save settings popup when closing >after you fix the problem?
-Bob” Physical COM port connected to the K3. It’s an FTDI USB-toRS232 media converter that works fine with anything else connected to the K3. Yes, have attempted to save the Fldigi configuration in the pop-up a countless number of times. Paul, W9AC On Mon, May 23, 2016 at 3:13 PM, Paul Christensen <[email protected] <mailto:[email protected]> > wrote: Dave, Correct. I must always initialize Fldigi with my K3. Once initialized, it's works fine. If I close it and re-open, initializing is needed again. Paul, W9AC On Mon, 2016-05-23 at 13:19 -0400, Paul Christensen wrote: > Jerry, > > Thanks for the tip. I'll use a macro in Fldigi if there's no simple > solution available. > > Paul, W9AC Paul, If I understand you correctly, you set things up in FLDigi, get them working, and then if you close the program, and restart it, the rig is no longer controlled. Is that correct? -- 73's, and thanks, Dave (NK7Z) For software/hardware reviews see: http://www.nk7z.net ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] <mailto:[email protected]> This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] <mailto:[email protected]> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
