What's the purpose of the 5.6k resistor?
I use a Ten Tec 701 hand microphone with no resistor with good audio. I use a
Ten Tec 706 desk microphone with no resistor but it loses some of it's lows.
Tried substituting a 9v battery fo0r the bias voltage, but it made no difference
in the audio. The MD2 and MH2 tend to overdrive my particular KSB2.
73 de NA8M
John
I use a TenTec 701 hand mike. It is a little smaller than the MH2 and comes
with a 4 pin connector so you will need to go to Radio Shack and get an 8 pin
connector and install it in place of the 4 pin. The interface is the same as
the MH2 with the 5.6k resistor for bias required. Works good and is
inexpensive ($28)
Don Brown
KD5NDB
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
