The K3 (K3S) can also be turned off safely (and store the current
settings) by using the PS0 command - see the Programmer's Reference.
That command cannot be used to turn it on (there is no power to the K3),
so the POWER_ON pin in the ACC connector can be pulled low by an
external device.
If you simply pull power, the current settings will not be saved, and
could result in having to reload the firmware to get it going again.
73,
Don W3FPR
On 5/31/2016 8:41 PM, Jim Brown wrote:
On Tue,5/31/2016 4:22 AM, j...@kk9a.com wrote:
How do you save the current settings? I think most of us at some
point in
our lives have had a power failure while operating.
Turn the K3 off with its power switch and turn it back on. You will,
of course, have to do that each time you change settings. :)
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
