Guess I have been lucky. For the past year or so I have been using a Daiwa 2 position coax switch between my K2 and TS-950SDX to the amp. While listening on the 950 through the coax switch I listen to the K2 on the low bands using my receive antennas. If I want to use the K2 to transmit I use the coax switch. So far no problems. 73, N2TK/NP2, Tony
PS - All set up here at WP2Z for this weekend using my K2. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Stuart Rohre Sent: Friday, March 03, 2006 3:09 PM To: Ed - K9EW; Lee Buller Cc: Elecraft Reflector Subject: Re: [Elecraft] Coax Switch between two rigs My measurements on ham grade coax switches show 40 dB or less isolation between positions. IN FACT, 60 dB is high even for a commercial grade switch. The simple types from MFJ that are wires to a multiposition wafer switch do not shield quite long wire runs from the adjacent connectors. Those are the long rectangular boxes with UHF jacks all in one row. Stuart K5KVH _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
