Solution Thanks for the help either on the reflector or direct. I found the problem in the end. This was brand new K3S I was setting up. Since I wanted to use N1MM+ as voice keyer, I had never run it with MAIN:MIC set to Line. Hence the “mic gain” for the LINE input was set to zero. Changing MAIN:MIC to Line first, increasing the gain so that the audio was working and then going back to MAIN:MIC to RP (with MAIN:MIC+LIN ON) worked.
73 Paul M1CNK > On 4 Jun 2016, at 18:32, Paul Wilton <[email protected]> wrote: > > I’m trying to set up a K3S with N1MM+ and am having problems with the TX > audio. I have connected the K3S via USB to my windows PC and with Audacity > have proved that I can receive audio over the USB connection using the > built-in soundcard in the K3S. However, I cannot make it go in the other > direction - ie get the K3S USB soundcard to modulate the output. > > My desire is to get N1MM+ to be the voice keyer. I have got a headset > plugged into the 3.5mm sockets on the rear of the K3S. This works. When I > ask N1MM+ to transmit audio, then the K3S goes into TX. However, I cannot > heard the computer generated audio in my headset - all I can hear is my own > breathing into the headset mic (hence proving that that the monitor function > works). Also, no RF is going out. MAIN:MIC is set to RP, MAIN:MIC+LIN is > set to ON. > > Am incorrectly assuming that I can use the K3S soundcard in this way? If > not, what am I doing wrong! > > 73 > > Paul > M1CNK > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
