It is best to use CW or Tune or even AM to check power output.
If you don't speak into the mic in SSB mode, the output should
be zero, as the carrier is suppressed and with no audio, there
is no side band.
73 Bill AE6JV
On 6/7/16 at 9:49 PM, [email protected] (David Davis) wrote:
I might have an RF out issue with my KX3 but I am not sure how to test it.
I have an Elecraft DL1 and a DMM that I figure I can use to check the RF
voltages and verify the power out. However, I am not sure of the exact
process on how to do this. If I am keying the mic on SSB do I need to
speak into the mic to be able to measure the voltages or just key the
mic with silence? I would assume I need to be speaking into the mic.
The reason I ask this is because if I just key the mic with silence and
the radio set for 10W with a input power supply of 13.5V DC I measure
4.7mv DC at the TP1 on the DL1 unit.
If I speak into the mic I see voltages from 11 - 18V DC from the TP1 on
the DL1 unit. It seems to me that I need to be speaking into the mic. I
figure if I was checking the RF out in CW mode I would need to key the
keyer in some fashion.
I know this seems like an elementary level question but I would really
like to verify the RF power out.
Any information is greatly appreciated in advance.
-----------------------------------------------------------------------
Bill Frantz | Since the IBM Selectric, keyboards have gotten
408-356-8506 | steadily worse. Now we have touchscreen keyboards.
www.pwpconsult.com | Can we make something even worse?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
