Seems like if you want to run such low power
levels, you'd go barefoot and not use the amp, Jim.
Phil W7OX
On 6/15/16 4:54 PM, James Bennett wrote:
I share my KPA500 with a K3 and a KX3. When I want to operate JT65 or JT9 I
normally run about 25 watts out, using the KX3 to drive the amp. With the KX3
set to 1.8 watts out, the amp gives me 25; with 2.2 watts from the KX3, I get
30 watts out from the amp.
But, what if I want to run 20 watts? Or 15? When I back the KX3 power level
below 1.8, the KPA500 shows zero on the LED power display. Does this mean it is
no longer amplifying, or is it actually amplifying but not enough for the
circuitry to determine how much?
Jim Bennett / W6JHB
Folsom, CA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
