Bill,
To make it simple, a single lever paddle works essentially like a
dual paddle one, push to one side for dots and the other for dashes. For
most operators, that is all that is needed. You will need to set the
menu item for keyer to tip=dot, or reverse if you are left handed.
If you are asking this question, iambic operation should not be your
worry at this point. Just make sure you have a cable that is 2 conductor
with a shield. One wire should go to the dot connection on the paddle
and the other to the dash side. Just make sure to note which color you
used for which. connect the dot side to the connect tip, the dash side
to the ring, and the ground to the ground on the connector. You'll be
ready to go.
Your next problem will be to get the feel, setting sending speed,
and adjusting the screws and adjustments on the paddle so it feels good
to you. Start slowly and work up.
------ Original Message ------
From: "Bill Ellis via Elecraft" <[email protected]>
To: "Elecraft Reflector" <[email protected]>; "Elecraft Support"
<[email protected]>
Sent: 6/26/2016 9:00:48 PM
Subject: [Elecraft] CW Setup
Hi ll,
Trying to set up a single lever paddle for my K3. The more I read the
more confused, for some reason, it gets. Can someone assist with this
hook up, do I use a stereo plug, and how do I set up the menu ?
Thanks/73's,
Bill, WB9CAC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
