Yes, it can be tricky (I call it "fiddly"), especially the first time.
If the connectors are aligned with the KRX3A pc board as seen from above in Fig 48 in the KRX3A manual, they are properly mated. 73, Ron AC7AC -----Original Message----- Removing the left side panel also makes it much easier to confirm that the connectors at the rear left of the KRX3 have been mated correctly. First-time assembly can be a little tricky, but becomes much easier after the connector pins have settled into their correct alignment. (The same is also true of the front-panel connectors, by the way.) 73 from Ian GM3SEK ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
