The most recent KXPA100 Programmer's reference is 1.18. No new commands have been recently added. What was added in 1.35 was the ability to HOLD the MODE button to toggle PA operate/standby (PA bypass).
The KXPA Utility uses ^OP to change PA bypass. This is described on page 19 of the KXPA Programming Reference. ^OP is not at all new. 73 de Dick, K6KR -----Original Message----- From: Elecraft [mailto:[email protected]] On Behalf Of Neil Zampella Sent: Saturday, July 16, 2016 06:31 To: [email protected] Subject: [Elecraft] KXPA100 - Programming Commands Hi all, Having just sprung for a KXPA100 to pair with my KX3, a PX3 and W2 are in my future, I've been playing around with setting commands up for it on DXLab Commander. I've setup the command to switch antennas, by adapting some command sequences created for the K2 & K3 and posted to the DXLab Yahoo group. There are some good resources there for Elecraft & DXLab integration. However, the KXPA100 Programmer's Reference available on the website is current to firmware revision 1.18, and the latest is 1.35. 1.35 added a function to disable the amplifier, but allow the KX3 to use the amplifier's ATU. This functionality is controlled by the KXPA100 utility, so there must be a command sequence that will perform this function. Has this command sequence been released to the public? Thanks, Neil Zampella KN3ILZ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
