When SWR is less than 1.3 (factory default), the KAT-500 should go into
“BYPASS” as I understand.
The LC values and MODE (Manual) from the previously selected antenna are still
shown in the config utility “Operate TAB”.
Also, the STANDBY LED has never illuminated when the SWR measurement is less
than the threshold set for entering the BYPASS mode.
Firmware installed
K3: 5.38
KAT-500: 1.67
de Ben W4SC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
