Misspoke, I meant "BYPASS" LED
Ben
-----Original Message-----
From: Dick Dievendorff
Sent: Friday, July 22, 2016 12:57 PM
To: 'w4sc'
Cc: [email protected]
Subject: RE: [Elecraft] KAT-500 Bypass indication/operation issue
When the ATU TUNE function discovers the SWR is less than the bypass
threshold, it should select "bypassed" as the tuning solution, and the
KAT500 Utility should show no L or C values selected. It should also show
the "bypassed" check box.
I don't have a "standby" LED.
The "BYPASS" LED means that the ATU's mode is "BYPASSED", not that the
current ATU tuning solution is "Bypassed".
73 de Dick, K6KR
-----Original Message-----
From: Elecraft [mailto:[email protected]] On Behalf Of w4sc
Sent: Friday, July 22, 2016 09:09
To: Elecraft <[email protected]>
Subject: [Elecraft] KAT-500 Bypass indication/operation issue
When SWR is less than 1.3 (factory default), the KAT-500 should go into
“BYPASS” as I understand.
The LC values and MODE (Manual) from the previously selected antenna are
still shown in the config utility “Operate TAB”.
Also, the STANDBY LED has never illuminated when the SWR measurement is less
than the threshold set for entering the BYPASS mode.
Firmware installed
K3: 5.38
KAT-500: 1.67
de Ben W4SC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
