In my KX2 SN 567, I removed the BPF and KXAT2 boards in order to install the Gem Products replacement side plates. I had no trouble installing these on my KX3 and really like them. One article by KE4RG states that this procedure for the KX2 is "not for the timid," and I would now concur. After MUCH difficulty, I got both boards reinstalled and closed up the unit. However, upon power-up, I received an error message "ERR ATC d=001."
The manual entry for this error message suggests removing and re-installing the KXAT2 board, making sure the 8-pin connector is properly mated. However, the ol’ hands and eyes must not be what they used to be (if they ever were), and it took me over an hour to get it plugged in the first time. It’s extremely difficult to see the KXAT2 board pins and determine if they are properly lined up, while maneuvering the KXAT2 board past the BPF board and antenna connector. Before I make another attempt, I thought I would check if anyone has any hints to increase my chances of success for this procedure. Thanks. Bob, WO3E This e-mail message is intended only for individual(s) to whom it is addressed and may contain information that is privileged, confidential, proprietary, or otherwise exempt from disclosure under applicable law. If you believe you have received this message in error, please advise the sender by return e-mail and delete it from your mailbox. Thank you. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
