Couple questions: 1) What radio, K3 or K3S, or K2/100?
2) which antenna, 1 or 2? 3) You said you turned the “temps down to a more reasonable 23C…” I don’t recall a temp setting, only a REF to current room temperature calibration step. 4) What is the voltage shown on the front panel display? …billc nr4c > On Jul 27, 2016, at 11:52 AM, Richard Fjeld <[email protected]> wrote: > > I apologize for this, but being it's a new rig it has to be said; could there > be any confusion in the antenna jack selection? > I haven't followed how it is equipped. > > Dick, n0ce > > > On 7/26/2016 7:48 PM, Chris Kimball wrote: >> I'm a new owner and all worked fine. After an absence of a few days I came >> back to no power out, or , at least, very little. >> >> Rig is the 100W version with ATU working into a dummy load. In CW mode >> adjusting the power level to 70W produces only a one segment power out. >> Running the ATU produces a 5W indication, the usual searching rumbling, but >> no resultant SWR. The Test mode is NOT in operation. >> >> I have restored to the last working config via K3 Utility, but suspect I >> must have "hit" something to limit the power. The FP and AMP temps were too >> high (35C) when the problem was noticed. I set them down to a more >> reasonable 23C without effect. Input voltage is 12.8V. >> >> Probably something trivial, but suggestions would be appreciated. >> >> Chris >> NQ8Z >> >> >> >> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
