Aaron,
It may be that it is not locked, but that the VFO encoder is not working
because the encoder board is contacting something on the back of the
Control Board.
Remove the top cover, then remove the 2 screws fastening the Control
Board to the Front Panel. Tilt the top of the Control Board toward the
rear of the K2 and see if it starts working.
If that fixes it, put a piece of plastic or card stock cardboard behind
the Control Board in the area of the encoder board and then put the 2
screws back in. Check to be certain it works with the screws snugged
before replacing the top cover.
73,
Don W3FPR
On 8/30/2016 1:45 PM, Aaron K5ATG wrote:
I was running PSK on my K2 and my cat got up on my desk and started moving
the VFO knob off frequency. So I decided to put on Lock and pushed the
button until it told me that it was locked, everything was normal. Then I
tried to unlock it and it would not work. I turned it off and restarted it
and everything is still locked. I unplugged it and again it is still
locked. The decimal point is not flashing. I looked in the K2 Manual and
could not find a place where I could resolve the problem.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
