John,
Normally the P3 does not show signals from the subRX. The IF out is
only from the main RX.
Unless you have added an IF buffer amplifier and IF output to your
SubRX, you will not see signals from the subRX on your P3.
73,
Don W3FPR
On 10/3/2016 10:55 AM, John E Bastin wrote:
On Oct 3, 2016, at 10:19, Don Wilhelm <[email protected]> wrote:
John,
The most common cause of that problem is the SubRX antenna selection - that is
a per band setting.
Go to 40 meters and get into BSET - then tap the RX ANT button.
If that does not restore proper operation, contact Elecraft support.
I’ll check that, but it seems that if there was no antenna, there would be no
signals in the sub rx on 40 meters, and I’m seeing the signals on the P3, I
just have no audio.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
