Ron,
This was into a dummy load.
I had it into the KAT100 which was disabled and unplugged. So only the
feedline was left connected though the ATU. Once I removed the KAT100 it
worked.
With the AT removed I did check power output into a dummy load and got the
following
160- 131 watts
75- 118 watts
40- 119 watts
20- 54 watts
17- 55 watts
15 -98 watts
12 - 78 watts
10- 99 watts.
So 20 and 17 are down and 12 slightly??
So I am thinking it must be ATU related and not the 100watt amp section.
Thanks
Rich
kd0zv
----- Original Message -----
From: "Ron D'Eau Claire" <[EMAIL PROTECTED]>
To: "'Rich McCabe'" <[EMAIL PROTECTED]>; <[email protected]>
Sent: Saturday, March 18, 2006 4:35 PM
Subject: RE: [Elecraft] Problems on 40M with 100 watt section
Rich, KD0ZV asked:
I just noticed that when I am on 40 meters and I am on the 100watt output, I
cant transmit. I think something is resetting the MCU because I see
"elecraft" flash. It works up to 10 watts without any problems on 40, but as
soon as I go above that acts up. All other bands work fine on the 100 watt
part.
I dont see anything in troubleshooting but plan to look through the
archives.
Any ideas
-------------------------
Frequency sensitive oddities like that are usually the result of RF voltages
getting where they shouldn't.
Try transmitting into a good dummy load and see what happens.
Ron AC7AC
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
