Dave,
Interesting problem. I used used RMS Express, but I used a SignaLink
USB for interface and T/R. I had no problems this way. Everything seemed
to work as I would have expected.
73,
Barry
K3NDM
------ Original Message ------
From: "Dave" <[email protected]>
To: [email protected]
Sent: 10/29/2016 12:32:52 PM
Subject: [Elecraft] KX3 & RMS Express - T R latency
Howdy,
I'm using an old laptop to connect my KX3 to winlink system. Using the
KXUSB for control, and laptop soundcard jacks to KX3 phones and mic
jacks.
Works fine, except that RMS Express gives me a Timeout message for T-R
latency - apparently my T - R switching is too slow? Any suggestions
on
what to change to help this out?
Using DATA-A, ALC off
On my old full size rig I used a signalink to interface and I just
cranked
the delay knob full CCW which did the trick - since I'm not using the
signalink here I'm at a loss - no easy knob to turn!
Thanks,
Dave
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
