Well, 100ms would definitely be too much. I'll give vox a try - I'm sure that will work after I figure out the settings. Thanks! Lack of built in sound card interface is one area I think the kx3 is deficient - I would for sure have purchased that option if it was given. Dave
On Oct 29, 2016 2:17 PM, "Brian Waterworth" <[email protected]> wrote: Had you considered using the KX3's VOX capability rather than the TX-RX commands through the USB interface? For all intents and purposes, the signalink is just a vox-in-a-box. The KX3 has two menu items to tweak vox operation. I have VOX GN = 015 and VOX INH = 030. You'll have to play with Mic gain and sound card output to make sure you have no more than four bars of ALC (with the fifth bar very occasionally flickering). I use this set-up for my KX3 digital operations and it is very responsive. >From the KX3 programmer's reference, there can be a 100ms lag in responsiveness to USB serial commands. Also, depending on how much polling RMS Express is doing against the KX3, this could exacerbate the lag of the TX-RX commands. I hope you figure it out. The KX3 is a very awesome rig and produces such a clean digital signal when set-up correctly. regards, Brian VE3IBW On Sat, Oct 29, 2016 at 12:32 PM, Dave <[email protected]> wrote: > Howdy, > I'm using an old laptop to connect my KX3 to winlink system. Using the > KXUSB for control, and laptop soundcard jacks to KX3 phones and mic jacks. > Works fine, except that RMS Express gives me a Timeout message for T-R > latency - apparently my T - R switching is too slow? Any suggestions on > what to change to help this out? > Using DATA-A, ALC off > On my old full size rig I used a signalink to interface and I just cranked > the delay knob full CCW which did the trick - since I'm not using the > signalink here I'm at a loss - no easy knob to turn! > Thanks, > Dave > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
