Hello Marty, I don't remember seeing any response to your question so here is what I have found with my KPod:
The K3's tuning rate is determined by VFO CTS, FST and CRS and there are two fine rates (1 Hz and 10 Hz) and a course rate (100 Hz) depending on the FINE/COARSE switch. So when my CTS is 200, the K3 tunes 200 Hz, 2 kHz and 10 kHz per revolution. The normal power-on KPod tunes 100 Hz, 1 kHz, and 5 kHz per revolution. (it divides by 2). Holding F3 when power-on the KPod tunes 50 Hz, 500 Hz and 2.5 kHz per revolution (divide by 4). Cheers, Fred KE7X For all KE7X Elecraft books, see www.ke7x.com<http://www.ke7x.com> (A macro programming book is coming soon.) ________________________________ From: Elecraft <[email protected]> on behalf of Marty Koszewski <[email protected]> Sent: Monday, November 21, 2016 3:18 PM To: [email protected] Subject: [Elecraft] K-Pod MCU 1.09 'F3 Power Up' Question I installed the latest K-Pod firmware - MCU 1.09. The release notes state "Adds a power-on feature: if the F3 button is held during power up the K-Pod encoder uses a divide by 4 scaling factor." I do not notice any difference when powering up holding the F3 button. What is the 'F3' power-up supposed to do? I thought it might address the 4X VFO knob speed difference between the K3 and the K-Pod (my K3s VFO is still 4X faster than the K-Pod). Thanks. Marty - N1VH ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
