Ahhh....I shall gather up my courage and press onward with my first KX2
update.....Thanks and 73,Stan WB2LQF
On Mon, Nov 28, 2016 at 07:17 PM, Wayne Burdick wrote:
Hi Stan,
I would use the latest "one-click" production firmware release (MCU
2.69/DSP 1.49). This corrects a DSP problem that in rare cases could
result in the DSP not sampling signals correctly.
73,
Wayne
N6KR
-----Original Message-----
From: Elecraft [mailto:[email protected]] On Behalf
Of stan levandowski
Sent: Monday, November 28, 2016 4:08 PM
To: [email protected]
Subject: [Elecraft] (KX2) - Randomly Powers Up "Weird"
For the last couple of months my KX2 randomly comes up acting like
it has a very tight filter engaged although all screen indications
are normal. In plain language it sounds "hollow" as if it were at 50
Hz. Yet all screen indications are normal (for example, it shows 400
Hz from its last use). There are no error messages.
This is very random; not a regular event. When it does occur, all I
have to do is turn the power off and then immediately back on and
all is well.
My KX2 is connected to an SEC1235M power supply and is also
connected to the KXPA100 amplifier. It's always in CW mode because
that's all I use. This "weird" power up situation occurs even if
the KXPA100 is physically disconnected.
The KX2 otherwise works normally in all regards. My firmware is at
2.61, DSP at 1.46 and PA at 1.32. These are "as shipped" by
Elecraft at purchase time. My serial number is 0472.
Just wondering if this little issue has visited anyone else.
73, Stan WB2LQF
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
