Do you have "Allow Tx frequency changes while transmitting" TX
checked under Settings?
Ken
At 04:39 PM 12/21/2016, Howard Sherer wrote:
I have installed the new version of WSJT-X and when changing the bands on
my K3s, I get the ERR KEY code on the display and the K3s is forced into
Tx. I must power cycle the K3s to clear, but repeats when I go to these
bands again.
This occurs only on 80, 20, 17, 15, 10, & 6M, the other bands are fine?
Any ideas?
Howard AE3T
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
------------------------------------------------------------------------------
President and CTO - Arcom Communications
Makers of repeater controllers and accessories.
http://www.arcomcontrollers.com/
Authorized Dealers for Kenwood and Telewave and
we offer complete repeater packages!
AH6LE/R - IRLP Node 3000
http://www.irlp.net
"We don't just make 'em. We use 'em!"
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
